Part 2: Marking and classifying · Chapter 5 of 10 · 8 min

How to mark and refine an order block

The procedure for marking the zone, what to do when there is more than one opposite candle, and four ways of narrowing it (body only, near half, an H1 order block, a group of candles) with measurements on the engine's 149 zones.

The procedure

The engine marks an order block like this. You can do it by hand with the same steps.

  1. Look for a displacement: a candle with a body above 1.3 ATR.
  2. Go back at most 4 candles and take the last one of the opposite colour: it is the origin.
  3. Mark its low and high: that is the zone.
  4. If there is also an FVG at that spot, narrow the zone to the part they share. It happens in 38 zones out of 149.
  5. Measure the height in ATR and write down the invalidation level: a close beyond the far side.

The engine uses the whole candle and only the last opposite candle. Those are choices, and this chapter puts them to the test.

When there is more than one opposite candle

In 63 zones out of 149 (42%) the origin is preceded by another candle of the same colour: two or three bearish candles in a row before a rise, for example. The engine takes only the last one. You could take the whole group, from the lowest low to the highest high.

On those 63 zones, the zone of the last candle is 1.10 ATR tall (median): 48 are touched and 27 hold (56%). The zone of the whole group is 2.52 ATR tall: 54 are touched and 36 hold (67%). The group holds more, and the region is more than twice as tall. It is the effect you saw in chapter 3: the wider the zone, the easier it is for price not to close beyond the far edge. With the group the stop moves away.

Four ways to narrow the zone

We applied four variants to the same order blocks and measured the chapter 1 outcome (a 1.5 ATR reaction before a close beyond that zone's far side):

ZoneZones availableMedian heightTouched in 40 candlesHold
Full range (engine)1490.94 ATR114 (77%)62 (54%)
Origin body only1490.45 ATR113 (76%)55 (49%)
Near half (from the 50% to the near edge)1490.47 ATR114 (77%)48 (42%)
H1 order block inside the H4 zone1090.58 ATR76 (70%)34 (45%)

The narrower the zone, the less often it "holds" under this measure (54%, 49%, 42%, 45%). It is the opposite of the width effect: with the far edge closer, a close is more likely to cross it. It does not mean the narrow zone is worse. It means the hold rate alone does not compare the variants, because the stop changes too: halving the zone halves the risk. The right comparison is made in R, and we make it in chapter 9.

Figure 1 shows the variants on the same order block, on H4, from 11 to 14 January 2026 (the one from chapter 1, from $4,578.32 to 4,596.98). The origin candle's body runs from 4,581.99 to 4,585.50 and the near-half limit is 4,587.65. Price comes back on 12 January at 20:00 with a low of 4,581.00, just under the body. With the full zone the outcome is "holds". With the body only, "holds". With the near half, "gives way": a close below 4,587.65 arrives within ten candles.

Figure 1. The same order block in three versions: full zone, body only (4,581.99-4,585.50) and the near-half limit (4,587.65). The same visit gives different outcomes.Data: gold, XAUUSDT perpetual future (real candles) · 4 hours (H4) · from 11 Jan 2026 00:00 UTC to 14 Jan 2026 20:00 UTC.
Read the chart in words

H4 gold chart from 11 to 14 January 2026. A blue band between 4,578.32 and 4,596.98 dollars is the full zone. A smaller lilac band between 4,581.99 and 4,585.50 is the body only. A dashed pink line at 4,587.65 marks the near-half limit.

WhenWhatPrice
12 Jan 2026 08:00 UTCBody only4,581.99 – 4,585.50
12 Jan 2026 08:00 UTCEdge of the near half4,587.65
12 Jan 2026 08:00 UTCengine's full zone4,596.98

Times in UTC.

Refining on H1

For wide zones there is another way: look inside the H4 zone for the H1 order block, that is, apply the same rule to the H1 candles of the period in which it formed. The result is a much narrower zone.

Of the 36 zones above 2 ATR, 18 have an H1 order block in the period. The median height drops from 3.00 to 1.22 ATR. Of those 18, 16 get touched (89%) and 10 hold (63%). The sample is small, but the refinement removed the widest part without losing the level.

Figure 2 shows a case, on H4, from 28 March to 1 April 2026. The demand order block of 29 March (the 20:00 candle) runs from $4,443.56 to 4,524.13: 80.57 dollars, 5.5 ATR. On H1 the 19:00 candle gives a zone from 4,504.21 to 4,507.99: 3.78 dollars. On 30 March at 04:00 price comes back with a low of 4,475.00, closes at 4,529.37 and in the next ten candles reaches 4,683.60.

There is a limit. The visit's low, 4,475.00, sits 29 dollars below the refined zone. On a close the level was not violated, but a stop just under 4,504.21 would have been hit by the wick. Refining brings the stop closer and exposes it to wicks.

Figure 2. An H4 order block 80.57 dollars wide (5.5 ATR) and the H1 refined zone of 3.78 dollars. The visit's wick drops well below the refined zone.Data: gold, XAUUSDT perpetual future (real candles) · 4 hours (H4) · from 28 Mar 2026 12:00 UTC to 1 Apr 2026 04:00 UTC.
Read the chart in words

H4 gold chart from 28 March to 1 April 2026. A very tall blue band between 4,443.56 and 4,524.13 dollars is the H4 order block. A narrow lilac band between 4,504.21 and 4,507.99 is the refined H1 zone. Price returns, the wick drops below both, the candle closes above and price rises.

WhenWhatPrice
29 Mar 2026 20:00 UTCRefined on H14,504.21 – 4,507.99
29 Mar 2026 20:00 UTCfull H4 zone4,443.56
30 Mar 2026 00:00 UTCdisplacement4,520.88

Times in UTC.

A four-step routine

  1. Mark the zone with the engine's rule: last opposite candle, full range.
  2. If the height exceeds 2 ATR, look for the H1 order block inside the zone: it is the narrow version.
  3. Choose a variant (full zone, body, near half, H1) and write it in the plan. Do not change it after seeing the chart.
  4. Write the stop as a function of the variant, allowing for wicks: in the figure 2 case the wick reached 29 dollars below the refined zone.

Exercises

Chapter exercises

1. The origin of an order block has a range of 40 dollars and its body covers 18. With the "body only" variant, how tall is the zone?

2. In the sample the full zone "holds" 54% of the time and the body-only zone 49%, but the second is half as tall. How do you compare the two variants?

3. An H4 zone 3 ATR tall contains an H1 order block 1.2 ATR tall. What do you get by refining?

4. In 63 zones out of 149 the origin is preceded by another candle of the same colour. Which zone does the engine take?

Have a question or want to share your exercise?

Post in the community, or join the free signals room on Telegram.

Educational content, not financial advice. Trading involves risk.